Once the pairing is complete, your device will be connected to your Jib True Wireless Earbuds. You can now enjoy wireless audio and take advantage of the features offered by the earbuds. It’s important to note that the specific method of entering pairing mode may vary depending on the earbud model. Consult the user manual or manufacturer’s instructions for your specific Jib True Wireless Earbuds if you encounter any difficulties.

The color of the LED on the outer ring should turn from red to blue, then finally, to green. This will indicate that the reset has been completed, and the earbuds are ready to pair again.Remove both earbuds from the charging case, and wait for a voice prompt stating that the earbuds are on. Now that your Jib True Wireless Earbuds are in pairing mode, it’s time to open the Bluetooth settings on your device. The process may vary slightly depending on the operating system of your device, but the general steps are as follows: Now that your Jib True Wireless Earbuds are fully charged, it’s time to put them in pairing mode. Pairing mode allows your earbuds to be discovered by your device’s Bluetooth settings. Follow these steps to put your earbuds in pairing mode:

To charge your earbuds, place them in the charging case. The earbud LEDs will be solid red while charging. The Jib True have 6mm dynamic drivers in each earbud with a 20-20,000kHz frequency response, 98-103dB SPL, and <3% THD at 1kHz. They support SBC and AAC over Bluetooth 5.0 connection. There's no multi-device pairing support. The earbuds connect in a master-slave configuration, where one (master) connects to the source and the other (slave) to the master. Performance This same issue could also be interfering with your case lid when closing, if you’re having a hard time closing the lid correctly, this is an indicator that buds are not set correctly or the gels are interfering. Once both buds have been powered OFF, touch and hold the button on each bud for 10 seconds to completely reset them (this will power cycle them on and off again). Both buds will automatically power ON and the LEDs will simultaneously flash BLUE while they sync to each other.

With your device’s Bluetooth settings open, you are now ready to pair your Jib True Wireless Earbuds. Follow these steps to select the earbuds from the available devices list: It’s essential to note that your Jib True Wireless Earbuds may be identified by a specific name, such as “Jib True Wireless” or a similar variation. Refer to the user manual or manufacturer’s instructions to confirm the exact name of your earbuds. While the pairing process for Jib True Wireless Earbuds is generally smooth, occasionally you may encounter some issues. Here are a few troubleshooting tips to help you overcome common problems: Unpairing your Skullcandy wireless earbuds from your device is a critical first step toward a successful reset. This prevents your earbuds from attempting to connect with your device as you’re resetting them. For the optimal Mono Mode functionality, first Power ON and pair your buds to your device normally or as described in our troubleshooting section. This will ensure the seamless transition between Stereo and Mono modes.