Locate the switch that indicates the choice of using heated air or room temperature air. Move the switch to the desired setting. Included are 3 components: the electrical cord, the plastic plug housing and the prongs/holder. Make sure your hands are clean and dry before beginning installation. WITH INTELLIGENT RESERVATION FUNCTION】Convenient reservation function is installed. When the reservation button is pushed, the LED light starts to blink. The reservation button defaults to 6 hours.

Boot Dryer Shoes Dryer, Portable Footwear Dryers Scienbeauty Boot Dryer Shoes Dryer, Portable Footwear Dryers

The appliance has no user-serviceable parts; any other servicing should be performed by an authorized service representative or a professional center. ODORS ELIMIATING】Built-in ozone deodorizer system helps to eliminate the odors caused by sweat and bacteria, preventing the growth of mold. Place each of the Ultra Dryers into any pair of shoes, boots, skates or cleats (logo side facing up).

If ignition doesn’t occur within 2-3 attempts, place your thumb over the large hole directly behind the retaining washer and relight. Once lit, leave your thumb over the hole until the heater warms up (about 15-30 seconds). There will be a small blue flame in the center tee. The Go! PEET Dryer uses Positive Temperature Coefficient (PTC) heating technology to assure safety. PCT heating elements are small ceramic stones with self-limiting temperature characteristics. PTC stones are energy efficient and have fast heating response times that plateau once the pre-defined reference temperature is reached. This technology has been installed and set to a predetermined temperature that maximizes the effectiveness of the dryer and will not allow it to overheat. The personal hydration bladders should not have liquids still in them when placing them on the Hydration PEET Dryer. The dryer is designed to effectively remove residual liquid that’s left behind to prevent the growth of mold and mildew. Using the thumb and first finger on your dominant hand, grab the prongs. While squeezing them tightly together, grab the plug housing firmly between the thumb and first finger of your other hand. Firmly slide the housing away from the prongs.

Dryer Comparison - October 2023 Lnideas Electric Shoe Dryer Comparison - October 2023

The Go! PEET Dryers will get warm, reaching their maximum temperature in 10 minutes, but they do not get hot. This product uses natural thermal convection technology; there are no fans or moving parts, therefore it will not blow hot air or make noise. Rotate the dial to select the desired length of time for drying. The maximum time is 180 minutes or 3 hours. Time is displayed on the LED readout and will count down until time expires when the unit will automatically shut off. Fold down both prongs away from their holder until you feel resistance and remove the electrical cord. Slide the plug housing off the cord. The PEET® Dryer is designed for easy use and long service. When you follow these simple instructions and guidelines, the PEET Dryer will dry your footwear or gear safely and efficiently. Drying time depends on material and saturation. ​

Loosen the tongue and laces of the footwear and place 1 Power Cell PEET Dryer in each shoe approximately 1 inch from the toe. This will allow the warm air to more freely throughout the shoe for proper drying. Slide the HIGH/LOW selector to the desired ozone setting. In HIGH mode, ozone is generated until the PDM is turned off. In LOW mode, the PDM cycles on and off generating ozone O3 50% of the time when the PDM unit is turned on. Best for use in occupied smaller rooms. LOW MODE is recommended for routine, moderate odor and for use in smaller spaces. Intelligent Timer】Set different working time for different kinds of shoes (up to 99 minutes). Easy to reduce power consumption. Hydration PEET safely and quietly dries bladders/reservoirs in 2-3 hours. SafeKeeping PEET Dryer (M10)