The scratch-resistant screen protector prevents scratches and other unforeseen "accidents" when the resin leaks. With a light transmission of up to 95%, the screen protector not only protects the display but also ensures outstanding printing accuracy at the same time.

A layer height of 0.25mm is a perfect mix between amazing quality and a fairly good printing speed. Best Exposure Times for Resin 3D Printing Your lifting distance should be high enough that it gives your models clearance to nicely come off the FEP film, and not too high that it unnecessarily increases your printing time significantly. For layer lines, the orientation is going to have a large effect on how visible they are, since the Z-axis provides the highest resolution accuracy. If you want details in a certain part of your model, make sure it is printed vertically rather than horizontally. Best Raft Settings for Resin 3D Printing Since the exposure time for bottom layers will be high as compared to normal layers, a lot of bottom layers may result in longer printing time, though not significant in comparison to the whole print.You do have to keep in mind that the best precision comes about in the Z-axis too, so having the most intricate details along the Z-axis makes a lot of sense. A balance is needed to get the print orientation perfect. What is Light-Off Delay in Resin 3D Printing?

The LighTurbo matrix has been optimised to make the parallel light source even more stable and uniform. This effectively reduces layer lines on the one hand and completely eliminates grid lines on the other. Nothing stands in the way of vivid details and fine, smooth surfaces!There are quite a few lifting and speed settings with resin 3D printing, but a good value is something that is fairly slow. People tend to go with a lifting speed of 1-3mm/s or 60-180mm/min. It can put more strain on your supports and overhangs. Best Anti-Aliasing Setting for Resin 3D Printing Photon Mono 2 is equipped with a laser-engraved aluminium alloy platform. This features outstanding flatness, which greatly improves model adhesion and therefore printing success rate. The laser-engraved platform prevents the model from falling off or warping. Since I have been using a few inexpensive FDM, I am accustomed to having an open-case design where both the cables and the connectors aren’t really contained (it makes sense since the arm needs to move in certain directions). So, I was immediately surprised by how compact the Anycubic Photon Mono 4K was and how there were no exposed wires or cables. At 15.1 x 8.9 x 8.7 inches (38.3 x 22.7 x 22.2 cm), it won’t occupy that much from your table, but don’t let that fool you, a resin 3D printer will occupy your entire desk with all the accessories needed for cleaning the models afterwards.