Apply second coat as above. The second coat must be applied the same day as the first. If the first coat is left to dry overnight then the second coat will not adhere to the surface correctly Be mindful that it is waxed-enriched and that once these waxes are dried, they act to repel liquids, which would include an additional coats. Don't try to coat the whole project with one coat before getting onto the next coat. Instead it is better to paint sections in in time chunks of 2-4 hours. Minimum of 2 coats is required - subsequent coats must be applied on the same day no longer than 8 hours apart Colour Supplies do not accept any responsibility for parcels once left, from the choice made by the courier on delivery, should they go missing or become damaged.

Stir thoroughly before pouring contents into a Cuprinol sprayer. Overspraying surrounding areas can be minimized by avoiding spraying in windy conditions and by using cardboard or plastic as a shield. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. Before full application of Cuprinol Garden Shades, we always recommend testing a small area first, before beginning any project to ensure that you are happy with the colour and overall look of the finish. Apply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required. The final colour will vary depending on the surface and number of coats. If adhesion is inadequate on previous coatings, lightly sand before application. Make sure wood has been pre treated with appropriate wood preserver to prevent wood and decay. A. It's important that you use a wood preservative that doesn't contain wax, oil or silicone as these will prevent the paint from penetrating and adhering to the wood. Wood preservers that are advertised as being waterproof and resistant to weathering often contain wax, oil, silicone or a combination of these. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergentSpecially designed to colour, protect and brighten up your garden furniture, shed & fence. Cuprinol Garden Shades allow the natural texture of the wood to shine through Don't apply in temperatures below 5°C, in damp conditions or if rain is likely before the product has dried. Low air temperature and or high humidity may prolong the overall drying time of the product. Before you begin, make sure that you always stir the product thoroughly before emptying the contents into the sprayer and refer to the sprayer instructions for full instructions before every use. Before you begin, ensure that any nearby areas have been covered encase overspray occurs. Any overspray that may occur should be cleaned up immediately with water and household detergent.

Q. Is Cuprinol Garden Shades suitable for garden fences and is it solvent-based? Does it contain any wax? Free sachet delivery is available on all Rust-Oleum sachets. These are shipped direct from the manufacturer using Whistl. Can take 5-10 working days. Test a small area first for colour and adhesion: Colour the final colour will depend upon the type of surface, previous treatment and number of coats applied. If using more than one can it is advisable to mix them together in a container or finish in a corner before starting a new can. Adhesion: if adhesion is inadequate on previously coated surfaces, lightly sand before application.A. It depends on how long ago your shed and fence panels where oiled. Cuprinol Garden Shades paint is a water based product so any remaining oil or wax from previous treatments will likely repel the paint. If the timber hasn't been treated for a couple of years it may be OK. In situations like this we always recommend a test area before starting the main project to test adhesion. Q. Is Cuprinol Garden Shades suitable for a large log cabin / summerhouse at the end of the garden?