There is nothing you can turn rust into that is going to react badly in a fire and frankly, if that stuff leaves a coating, that will probably just burn off anyway.

Due to the many types of paint formulations and curing processes test compatibility of products at small scale before use. If the panel or item can be removed, soaking in a receptacle of Deox C solution can give great results. I'm VERY cautious about anything that could emit CO/CO2, as many of the symptoms of breathing that stuff are the same as the symptoms I have almost constantly anyway. On the mig forum there has also been discussion about the Lechler 29107 epoxy primer, which although described as 2 pack, is possibly non iso.

As with all treatments preparation is important:Remove loose, flaky rust with a wire brush and abrasive paper (or if favoured power tools).

Traditional paints and coatings applied to rectify corrosion problem areas usually give a disappointing performance, with rust quickly reappearing. As with all treatments preparation is important: Remove loose, flaky rust with a wire brush and abrasive paper (or if favoured power tools). The long-term performance of Hydrate 80 has been proven to significantly increase coating life in independent tests conducted by the German TÜV organisation under conditions of VDA 621-415 (6 cycles, or 1008 hrs) which included exposure to hot salt-spray, 100% relative humidity and drying atmospheres with each cycle lasting 168 hours. I've got Hydrate 80 for some light surface rust on the undercarriage, black hammerite, and dynax UC to go on the arches and components as its clear.

Of course, where steel is rotted through, I'll be cutting it out and welding in good metal, but I'm concerned about rust in pitted areas. I had a couple of hours where I didn't feel quite so wreched today, so I soldered up a couple of little pin holes I'd found on the outer seam of the tank. It also combines with surface moisture and oxygen, depriving the corrosion process of the conditions it requires. The long-term performance of hydrate 80 has been proven to significantly increase coating life in independent tests conducted by the German TÜV organisation under conditions of VDA 621-415 (6 cycles, or 1008 hrs) which included exposure to hot salt-spray, 100% relative humidity and drying atmospheres with each cycle lasting 168 hours.

Even sitting in the garage and sanding stuff for more than half an hour makes me ache from my ankles to my lower back these days, and today I stupidly kept doing half an hour until the pain built up to "Scream out loud" levels, then back into the house to lay down, take another painkiller, and whimper for a bit. Tested extensively by us in development stages, our products come out on top in testing and reviews, across the range. Does anyone else over the age of 45 get a vague feeling of "Wrongness" about mixing metric and imperial fasteners on one machine/tool/device? It's plated with a thick layer of some slightly soft metal that didn't seem to like the Deox C it had a long bath in, but as it's hidden by the lid, I'm not sure if I'm going to paint it.What is a great combination is the Deox C/Gel followed by Electrox (at least two coats) and a top coat.