Sorry tried to look for some pics but I dont have any and I actually just spent part of the day yesterday breaking down the mft bench and cutting it down to make room for some new equipment coming.

The Trax90 XL slides into your Makita track and holds firmly using our unique integrated sprung slide design, no need to make any adjustments or deal with tightening clamps.Ideally you want to use as long a rail as possible over that length as the fewer the joins the better.

I don't have any problems ripping full sheets using the FS 3000/2 and the parallel guides, but all this does is ensure uniform width for the long rips. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . The Empire square is 12" long, which means towards the end there will be minimal sagging due to the weight. Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). The ends of the guide rail are most susceptible to damage and the square depends on butting against good straight undamaged rail.Compatible with Festool / Makita / Triton / Evolution / ErbauerWith the additional 30mm or 60mm bevel adaptors screwed in on the square's bottom side, the Rail Square can be used with bevelled edges like worktops.

Adjust the wood strip using the method or similar method until its on the money and then place it on the sheet to be cut, the difference in the 1. Then just square up the short ends, I use my hkc55 for this if they are small enough or just old school with a normal engineers square against the back of the rail.The goal of this rail square adapter was to be an affordable option that will still produce accurate 90/45 degree alignment.