I know the pedal has a 3 band EQ, but boosting the mids / cutting the others does not seem to help much. It sounds like the mid control is tuned to a slightly higher frequency than I'm targeting. I think I can get the same kind of sound with a bandpass filter set on the same frequency than Character Stage and softclipping stage and a final blend with clean signal...

band EQ section and controls for level, gain and voice gives you huge scope for tone shaping to get the most accurate all California cream sound! it allows you to tailor your sound just the way you like it. A truly great, natural tube sound with none of the ‘fizz’ you expect from a budget pedal. Rugged Aluminium case and bypass circuitry make this the best value pedal around! Looking into the Joyo Wooden sound, it is very hard to find a pedal that this could be a clone of. The closest thing I can think of is the Boss Acoustic Simulator. However, this Wooden sound is its own unique pedal. Simulating the acoustic guitar is one of the hardest effects to get right. And Joyo has hit the nail on the head with this Acoustic Sim. Whilst Acoustic Simulators will of course never really sound like the real thing. This is about as close as it gets to achieving a well rounded acoustic tone from your electric guitar by the stomp of a switch. Ironman Amp Simulators or, could it be related to the 42nF instead of 4.7nF cap thing that you spotted? There are a lot of comments that this pedal has way too much bass and I wondered (long shot) if the two might be related. Looking closely at the Joyo Extreme Metal, it is quite easy to see that this is pretty much a very close copy of the EHX Metal Muff. The Joyo is enclosed in a smaller casing which could be considered a good thing for many. Both the Joyo Extreme Metal as well as the EHX Metal Muff feature an epic Boost switch which allows you to add more “tops” to your guitar sound. Allowing you to cut through the mix. Joyo Power Tune Reviewto provide information about you to our contractors, employees, consultants, agents or other third parties for the purpose of providing the services to you; The California sound is also brilliant on bass as well as guitar. Giving a massive low end sound whether you're using it as a DI or an overdrive. It’s worth pointing out that the bass control provides about 4 times the amount of low-end you’ll ever need. That said, the Mid and Hi controls are far more useable. So, you’ll need to play with the pedal’s EQ controls to fully understand how they work.

The top row contains a three-band EQ: Bass, Mid, High. Pretty standard and simple to understand. So far, so good! Each of these knobs has a wide range, making it possible to easily shape your guitar’s tone, no matter the situation.A Drive control completes the second row and allows you to add more or less distortion to your guitar sound. Working in partnership with the Voice control, you can get a range of overdriven tones by adjusting these two controls and keeping the EQ controls at 12. Fortunately, Joyo has created a more than a sufficient clone of this Suhr Riot pedal. However, this is not a direct clone as there are some differences between these two pedals. For example, the Suhr Riot comes with an extra voicing toggle switch. Which lets you switch between three different high gain distortion voices. We may share your personal information with service providers utilised by us in the provision of the Services to: Up to now the only one I could not put hand on was the VT Bass. I trust the values from the tables on this thread but they are a little odd. The gain is too high and the waveform is being cropped, so if someone have this beauty and can get some good hi-res gutshots from the inside of it , to get the resistor values, at least, will be a nice start point to have a consistent schematic for this version also. With plenty of volume available, you can use it as a clean boost. Plus, you’ll find you have more than enough volume lift for every situation.